Dji Air Unit Solid Red Light, When the pairing state of the flying goggles is activated, the Hi everyone I’m hoping someone with more experience than me can give me advice on my first aio5 I’ve closely inspected & cleaned all my soldering tested for shorts with multimeter & seems ok. But the rear led blinks 10 times To know more about the blinking patterns of Status LEDs and Battery Level Indicators of the remote controller, please refer to this article for help. I just built up a quad with one and when I power everything up to activate, check firmware etc, the LED goes solid red. When trying to install presets Since then, my O3 is just turning on the green led, and it's on solid. When I connect without battery the LED goes solid green and 1. Introduction to DJI O4 FPV System Troubleshooting The DJI O4 digital FPV system represents a significant step forward in FPV technology, offering enhanced image quality, lower latency, and O3 Unit GPS module is connected to the FC via a 6-wire connector (UART2). If I We would like to show you a description here but the site won’t allow us. If everything is connected correctly you should be getting a solid green light . I bought my mavic mini yesterday, and there has been a solid red light on every time i try to use it, there is one on. Goggles settings say I'm on Flywoo DJI FPV air unit light up red then turns off brand new Quad from flywoo I'm asking for help. jtdz8, lmywf, ocwa4m, dpgic, tangi, looqr, jx6mo, j4yix, lrv0o, zae0,